Exporting and unknots...

Questions and discussions of a general nature about KnotPlot

Exporting and unknots...

Postby closedcurve on Wed Jul 29, 2009 8:38 pm

Is it possible to export knots in bulk (perhaps an entire catalog) as a list of control points in three-dimensional space, perhaps via a b-spline patch DXF? Alternately, is the format used by KnotPlot to save knots documented anywhere? Also, does KnotPlot include more than the one unknot in its catalog and/or is it possible to generate unknots (perhaps using TopoICE-X)?

I hope these questions aren't too basic.

Thanks,

Tyler
closedcurve
 
Posts: 1
Joined: Wed Jul 29, 2009 6:44 pm

Return to General

Who is online

Users browsing this forum: Yahoo [Bot] and 1 guest

cron