Page 1 of 1

Exporting and unknots...

PostPosted: Wed Jul 29, 2009 8:38 pm
by closedcurve
Is it possible to export knots in bulk (perhaps an entire catalog) as a list of control points in three-dimensional space, perhaps via a b-spline patch DXF? Alternately, is the format used by KnotPlot to save knots documented anywhere? Also, does KnotPlot include more than the one unknot in its catalog and/or is it possible to generate unknots (perhaps using TopoICE-X)?

I hope these questions aren't too basic.

Thanks,

Tyler